Tool

Surface

Revolve Surface

Revolve Surface

Surface

Create a surface by revolving a profile curve

Docs for v4.0.3, the latest version.

ID

tool-surface-revolve-surface

Group

Surface

Plugin

Tool

Keywords

revolve
srf
rev
5 inputs, 1 output, 1 config port

Ports

Inputs

5

What the node takes in, from wires or typed values.

Profile

Curve

Profile curve to revolve

Origin

Point

Default [0,0,0]

Axis origin to revolve around

Direction

Vector

Default [0,0,1]

Axis direction to revolve around

Start Angle

Number

Default 0

Angle offset to start revolve (radians)

End Angle

Number

Default 6.283185307179586

End angle of revolve (radians)

Outputs

1

What the node gives out, to wire into other nodes.

Surface

Surface

Resulting surface

Config

1

Settings on the node itself, changed in its panel.

Capped

Boolean

Default true

If enabled, the node adds cap surfaces to the open sides of the revolved result

Creation Method#

There are two ways to create the Revolve Surface node:#

  • Search panel

    • Double left-click in the workspace to open the search list.
    • Type relevant keywords:
      • revolve
      • srf
      • rev
  • Main menu

    • Menu > Nurbs > Primitive surface > Revolve Surface

Description#

The Revolve Surface node creates a surface by revolving a profile curve around a defined axis.

This version supports:

  • Start and end angles (partial revolutions)
  • Full revolutions (0 → 2π)
  • Optional capping of open sides

If Capped is enabled, the node will cap only the open sides with surfaces.
The node always returns a Surface. It does not generate or return a solid.


Inputs#

  1. Profile (Curve)
    The curve to be revolved.

  2. Origin (Point)
    Axis origin point.
    Default: (0, 0, 0)

  3. Direction (Vector)
    Axis direction vector.
    Default: (0, 0, 1)

  4. Start Angle (Number)
    Angle where the revolution begins (in radians).
    Default: 0

  5. End Angle (Number)
    Angle where the revolution ends (in radians).
    Default: 2π

Config port#

  • Capped (Boolean) If enabled, the node adds cap surfaces to the open sides of the revolved result (for example when the revolution angle is less than 2π). Default: true

Output#

  • Surface
    Returns a revolved surface.
    If Capped is enabled, additional cap surfaces are included in the result.

Steps#

  1. Create the Revolve Surface node.
  2. Connect the profile curve to the first port.
  3. Connect the axis origin to the second port.
  4. Connect the axis direction to the third port.
  5. Set the Start Angle (optional).
  6. Set the End Angle (optional).
  7. Enable Capped in the config panel if open sides should be closed with surfaces.

See Also#

Sweep 2
Ruled Surface
Loft Surface
Extrude Along

History

Added in v2.1.19

Oct 20, 2026